Manufacturer: Poly-MartAt Gutter Installation
1. Remove the existing Gutter Outlet from the roof guttering system.
2. Hold the new Gutter Outlet #4 against the fascia and against the
bottom of the gutter where the new outlet hole is to be. Use the
Gutter Outlet as a template, draw around the inside of the outlet to
mark the underside of the gutter for the new hole and cut out with tin
3. Refit the Gutter Outlet #4 to the main body #1 and place a small
amount of sealant in the sealant groove in #4.
4. Slide the Leaf Beater up against the fascia and position the Outlet
#4 over the gutter outlet hole and fasten the unit to the fascia with
two rivets or screws through the back of the body #1 and into the
5. The Leaf Beater is now ready for connection to the downspout. Do
NOT glue the Leaf Beater to the downspout. SECURE with a screw
for easy replacement.
6. Refit the Secondary Screen #3 then refit the Primary Screen #2 and
set on position 'A'. Observe the performance of the Leaf Beater
during an average rainfall and adjust down notch by notch until the
best operating setting is achieved.Mid-Mount Installation
To improve access for cleaning, Leaf Beater Rain Heads can be mounted down the wall at a convenient height. When pushing water over long runs and depending on the volume of water required to be moved, the Rain Head may need to be mid-mounted more than 4 feet above the discharge point.
It is important to note that when mid-mounting, the flow directional benefits of the rectangular gutter outlet supplied with the Leaf Beater will be lost. However this is to be balanced with the benefits gained from easier access for maintenance.
For mid-mounting, discard the top flow-directional gutter outlet. Cut the entry downspout at about 60 degrees, allowing 2" clearance between the pipe and the primary screen. This ensures the end of the pipe is parallel to the screen and helps direct the water onto the face of the screen most effectively.
Poly-Mart Warranty Details:
Poly-Mart carries a 1-year warranty on all accessories and specifically excludes the cost of labor for installation and/or removal of personal property. We are also not liable for personal/property damages. Poly-Mart is not liable for accessory failure if damaged by the customer.